Two schemes for detecting CMOS analog faults

A design-for-testability scheme for detecting CMOS analog faults was reported by Favalli et al. (see ibid., vol.25, no.5, p.1239-46, 1990). The authors propose two alternative designs, one for small circuits and another for large circuits, which require significantly less area overhead (about 1/4 to 1/3) than that of Favalli's design. With the proposed modification in the first design, the untestable problem, which occurred in Favalli's design, can be alleviated. Furthermore, the proposed schemes are also fit to be implemented in VLSI circuits     

Microstrip reflectarray antenna with offset feed

The authors derive and verify the concept of antenna focusing by a planar 'microstrip reflectarray' antenna. Experimental results from schematically distributed patch radiators with microstrip delay lines are consistent with the simulation results. The advantages and disadvantages of such an antenna are described. The measured overall antenna efficiency is approximately 48% at scan angles up to 30 degrees . These results demonstrate the feasibility of such an antenna.<>     

A hybrid wafer-dicing process for GaAs MMIC production

A dicing process for GaAs MMIC (monolithic microwave integrated circuit) wafers using spin-on wax for wafer mounting and a hybrid process of wet chemical etching/mechanical sawing for chip dicing is described. This process minimizes ragged chip edges and reduces generation of microcracks in addition to the elimination of the plated gold burrs on the backside of the diced MMIC chips. This process gives a uniformity of -3 μm across a 2-in wafer following the completion of the whole backside process. This GaAs chip dicing technique is amenable to production because it exhibits both a very high chip yield (>90%) and nearly flawless edges     

Differences in risk factors for being either a hepatitis B carrier or anti-hepatitis C+ in a hepatoma-hyperendemic area in rural Taiwan

This is a study of the differences in the risk factors for being either hepatitis B surface antigen positive [HBsAg(+)] or antibody to hepatitis C virus positive [Anti-HCV(+)] in A-Lein, a rural area in southern Taiwan, an area which also has a high hepatoma mortality rate. Three hundred eighty-five patients age > or =40 years participated in hepatoma screening at the A-Lein Community Health Center during 1995. Those who were HBsAg(-) and anti-HCV(-) or had coinfection of HBsAg(+) and anti-HCV(+) were excluded, leaving 293 patients: 109 HBsAg(+) and 184 anti-HCV(+). The anti-HCV(+) patients had a lower socioeconomic status (as defined by level of education and type of occupation) and were older than HBsAg(+) patients (P < 0.05). Those with higher alanine aminotransferase levels (ALT) also had a higher anti-HCV(+) to HBsAg(+) odds ratio (OR), and a dose response relationship was found, P < 0.0001. Anti-HCV(+) patients were more likely than HBsAg(+) patients to have a spouse who shared the infection, OR = 5.11; 95% CI, 2.30-11.28. Anti-HCV(+) patients were more likely than HBsAg(+) patients to have had blood transfusions (OR = 2.66; 95% CI, 1.20-5.89), frequent medical injections (OR = 2.64; 95% CI, 1.62-4.31), or injections by non-licensed medical providers (OR = 1.91; 95% CI, 1.18-3.09). Multiple logistic regression analysis showed that the significant factors for anti-HCV(+) patients vs. HBsAg(+) patients are drinking habit (OR = 3.45; 95% CI, 1.02-11.60), age (OR = 6.33; 95% CI, 2.93-13.68), and frequent medical injections (OR = 2.88; 95% CI, 1.65-5.03). The transmission of hepatitis C in A-Lein is closely related to low socioeconomic status, age, alcohol abuse, spouses being anti-HCV(+), and frequent medical injections, especially from non-licensed medical providers, including both pharmacists and those with no medical licensing whatsoever. These nonlicensed medical providers sometimes reuse needles to save money, which is a likely route of infection.     

Onset of gas self-induction and power consumption after gas induction in an agitated tank

The behavior of inducted gas from liquid surface and the; power requirements in an agitated tank using a mechanical agitator are studied in order to increase the amount of gas self-induction and the gas retention time for gas absorption. A 45° six-blade downward impeller turbine was utilized in this study. Air and water, air and 40 wt% 60 wt%, and 80 wt% of glycerin water, and air and 106 cP silicon oil were employed as gas and liquid phases. Variables which were studied included geometrical factors (immersed depth of impeller, baffle with and diameter of impeller) and the physical properties of the liquid (viscosity, density, and surface tension). The correlations for the onset speed of impeller and power consumption after gas induction in the agitated tank are established from our experimental results. The amount of gas self-induction from the liquid surface in the agitated tank increases with increasing impeller diameter and speed and decreases with increasing baffle width, depth of impeller and viscosity of liquid.     

Delayed delivery of surviving triplet after fetal reduction and spontaneous abortion

In multiple pregnancies, survival of remaining fetuses after premature death and delivery of one fetus is uncommon. We report a case of a triplet pregnancy that was reduced to twins at the 14th gestational week and then had preterm premature rupture of membranes and intrauterine fetal death of one twin at the 17th gestational week. To save the surviving fetus, delivery of the dead fetus and ligation of the umbilical cord at the cervical level were performed. We also performed McDonald cervical cerclage to keep the placenta of the dead fetus as well as that of the surviving one in the uterine cavity. After a series of aggressive procedures, including immediate administration of tocolytic agents, and antibiotic prophylaxis to prevent infection and preterm labor, the surviving fetus was delivered vaginally 73 days later due to intractable uterine contractions. After a 10-week hospital stay, the infant boy, weighing 2,500 g, was discharged without any sequelae. To our knowledge, this was the longest interval between deliveries in a triplet pregnancy reported in Taiwan. With adequate intensive management, a satisfactory outcome of the fetus and mother in such cases is possible.     

An efficient hierarchicaltraversal algorithm for ray tracing

Ray tracing has been shown to be an excellent technique for rendering realistic images. However, it is important to reduce the lengthy computation time resulting from the brute-force nature of the original ray-tracing algorithms. In this paper, two ideas are proposed to speep up the well-known hierarchical subdivision method. First, a new hierarchy traversal scheme is described to reduce the number of raybounding volume intersection tests for secondary rays. Then, a plane-sweep method is proposed to make fewer intersection checks for eye rays. Experiments and discussions are presented to prove the feasibility of our methods.     

Theory of gain in quantum-wire lasers grown in V-grooves

Theoretical calculations of gain, refractive index change, differential gain, and threshold current for GaAs-AlGaAs quantum-wire lasers grown in V-shaped grooves are presented. The theoretical model is based on the density-matrix formalism with intraband relaxation, and the subband structure is calculated within the effective bond-orbital model. For the quantum-wire geometry treated, agreement with the observed subband spacings is found. Because of the small overlap of the optical field with the active region for a single quantum wire, lasing threshold is reached only when several subbands are filled